Echelon LonMaker Bedienungsanleitung PDF herunterladen (Seite 217)

LonMaker User’s Guide 201

5. Specify the initial state of the replacement device’s application, and select the source of the

configuration property values and management of device-specific configuration properties as

follows:

State Set the state of the device application after the replacement device

has been commissioned. You have four choices:

• Default. The state of the replacement device’s application is

determined by the current setting under the New Device

Options box in the network properties: Device options category.

If the device was previously commissioned and is able to

communicate, the default state is the state of the device before

the current operation.

• Online. Places the replacement device in the online state. The

behavior in the online state depends on the device. A Neuron-

hosted device, for example, will run its application after it has

been commissioned.

• Offline. Places the replacement device in the offline state. The

behavior in the offline state depends on the device. A

Neuron-hosted device, for example, will not run its application

after it has been commissioned. This is the default and can be

used to bring up a system incrementally.

When a device is offline, portions of its application may still

function and it will still respond to Online, Wink, and Test

commands. An offline device still receives network variable

updates, but it typically does not process updated network

variable values or send network variable updates.

Resetting an offline device makes it go online, unless the device

is in the hard offline state, in which case it will remain offline

after a reset.

• Disable. Keeps the replacement device’s application disabled

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 422 423

Keine Kommentare

Echelon LonMaker Bedienungsanleitung Seite 217