kHz. This LED is only on the power-line
version.
Power Input Barrel connector power supply input for use
with the included power supply (Echelon
model 780x0 series for the free-topology
model). The included Tamura 420A12150P
supply should be used with the power-line
model.
10Base-T Ethernet Port Standard 10BaseT connection, type RJ-45.
LONWORKS TP/FT-10 Port For the free-topology model, an orange
Weidmuller connector (Weidmuller model
#134686) connected to an Echelon TP/FT-10
transceiver. This port exists only on the free-
topology model.
Serial Port Reserved for future use.
Service Pin Service pin is a recessed pushbutton used to
send a LONWORKS service pin message on the
L
ONWORKS channel. This button is also used
to perform a security access reset as described
in Security Access Reset.
Connecting and Configuring Your i.LON 10 Ethernet
Adapter
To connect your i.LON 10 Ethernet Adapter, follow these steps:
1. Remove power from the i.LON 10 Ethernet Adapter.
2. Connect the FTT Channel to the i.LON 10 Ethernet Adapter’s orange
Weimuller connector. This step is performed for the free-topology model only.
The power-line model communicates through the Tamura power supply.
3. Connect the i.LON 10 Ethernet Adapter’s 10Base-T Ethernet port to a
Ethernet Hub/Switch (TCP/IP network) that can communicate with your PC
or use a crossover Ethernet cable to connect the i.LON 10 to your PC directly.
4. Hold down the i.LON 10 service pin.
5. While continuing to hold down the service pin, apply power to the i.LON 10
Ethernet Adapter.
6. Continue holding down the service pin for about 10 seconds until the wink
and connect LEDs illuminate. This means that you have performed a
security access reset (see Security Access Reset, below) and you will now be
able to access all the web pages on the i.LON 10 Ethernet Adapter.
7. Set your PC’s IP address to 192.168.1.100 or any other IP address on the
192.168.1 subnet except 192.168.1.222 (Subnet Mask should be
255.255.255.0). You do not need to set the PCs Default gateway or DNS
Server.
8. Launch Internet Explorer 5.0 or later.
9. Point your browser to http://192.168.1.222/config. You will be
prompted for a user name and password to access these pages. The user
name and password are both ilon (lower case). When you log in, the status
web page appears.
4 i.LON 10 Ethernet Adapter Quick Start Guide
(159 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern